Corrections: Netbook Computer Carriers (PBA186)

July 29, 2021

On patterns dated before 072921 (see date in middle at bottom of each page), please make these corrections:

​Page 6, step I-C-4-b-i:

​ ​Change to: Mark the Back Strap Placement line by drawing a horizontal line from side to side 1-3/4" down from the top.

​Page 7, step II-H-2:

​ ​Front Pocket A was cut 7" x 12" (not 10" x 12"), so this step will use the 7" x 12" Front Pocket A (not the 10" x 12" pocket).

​Page 7, step II-I-1:

​ ​Back Pocket B was also cut 7" x 12" (not 10" x 12"), so this step should refer to the 7" x 12" Back Pocket B (not the 10" x 12" pocket).

​Page 8, step III-C-1:

​ ​Attach the Back Strap Fastener about 1/8" below the line marked 1-3/4" from the top.

February 12, 2013

On patterns dated before 021213 (see date in middle at bottom of each page), please make this correction:

​Page 5: Step "Make the Zipper/Side Strip":

​ ​You will position the zipper on a 2" x 17" strip (not 1" x 17").

​ ​The cutting instructions on Page 4 are correct.