Corrections: Just In Case (PBA250)

May 6, 2024
On Just In Case patterns dated before 050624 (see date in middle of bottom of each page), please make this correction:

​Step II-D-5-a on page 4:

​ ​The first sentence in the note in this step should read as follows:

​ ​ ​NOTE: The bottom bound edge of the pocket should cover the raw edges of Pocket A on the Small Case and should align with the line marked 8” from the top on the Large Case; adjust placement as needed being careful that the top edge doesn’t cover the magnet at the top.

December 07, 2021

On patterns dated before 120721 (see date in middle at bottom of each page), please make these corrections:

​Page 2, step I. CUT:

​ ​Please change the NOTE at the beginning of the cutting instructions to read as follows:

​ ​ ​NOTE: All dimensions throughout the pattern are listed as height (lengthwise grain) of fabric x width (crosswise grain) of fabric. Cutting instructions for the Case Body pieces are designed to make best use of fabric and will be rotated to be taller than wide when assembled. For best use of fabric, cut in the order listed. First set of dimensions or instructions is for the small; second set (in parentheses) is for the large.

​Page 2, step B. MARK:

​ ​Please add this sentence at the beginning of step 1:

​ ​ ​1. Rotate the Case Body (quilted fabric) so that it is taller than it is wide.