Corrections: Take A Stand (PBA273)

January 30, 2024

On patterns dated before 013024 (see date in middle at bottom of each page), please make these corrections:

​The section that describes the zipper sizes needed should read as follows:

​For the small (large) bag, you will need 48" (62") of zipper tape and 3 (3) pulls to make:

​Bag closure: 18" (22") single-slide zipper

​Exterior pockets: Two 15" (20") single-slide

September 10, 2023

On patterns dated before 091023 (see date in middle at bottom of each page), please make this correction:

​Page 2, Step 1-A.:

​Change the instructions for Using Directional Fabrics as follows:

​҂USING DIRECTIONAL FABRICS: If main/lining fabric is directional, instead cut two 13½” x 16” (18” x 19”) pieces for Quilted Set A Main/Lining. With right sides together, position the two pieces so that the “bottoms” of the design are together on one 16” (19”) side. Sew together along that side with ½" seam; press seam open. Proceed as directed.

June 08, 2020

On patterns dated before 060820 (see date in middle at bottom of each page), please make this correction:

​Page 4, Step II.D.1.c.:

​The Pocket A Border on the small is 2½" x 12" (not 2½" x 12 ½ "). Please change the text as follows:

​c. With right side down, position the bottom 12" (16") side of the prepared 2½" x 12" (3½" x 16") Pocket A Border below the marked line.

October 17, 2018

On patterns dated before 101718 (see date in middle at bottom of each page), please make these corrections:

​Page 3, Step B:

​Prepare the Carrying Strap Tabs and Carrying Strap. On part 4c (Prepare the Carrying Strap Tabs), for the LARGE size only, mark the horizontal line 9 1/4" up from the bottom.

​Page 5, Step B:

​Attach Carrying Strap Tabs. On part 1, for the LARGE size only, you will stitch along the previous line of stitching to the line marked 9 1/4" up from the bottom.

​Page 6, Step E:

​Attach Ends and Bind. On step 1, the end of the last sentence was omitted. It should read, "flip the piece over so that the lining side is up."

​Page 7, Step F:

​Attach Zipper. On part 7b, note that the measurement of the folded Zipper Binding will be 1” x 63”.

January 17, 2022

On patterns dated before 011722 (see date in middle at bottom of each page), please make these corrections:

​Page 5, Step III-C-3:

​In order to create two equal sections in Pocket C, please change the first sentence to read as follows:

​3. Create a division in Pocket C by marking a vertical line from the top bound edge of the pocket to the bottom bound edge 6" (8") in from the left and stitching along the marked line.

​Page 6, Step III-E-1:

​Part of the text in step 1 is covered by figure 19. Please change the first sentence to read as follows:

​1. Flip the piece over so that the lining side is up.